/////////////////////////////////////////////////////// EEPROM CALLS - USE WITH CARE

////////////////////////////////////// AUTONEWLINE

/////////////////////////////////////////////////// AD9851 - AUTO REFERENCE CLOCK

tune the timing of writing bytes.

/////////////////////////////////////// operational mode

SETTERS

microSeconds = 0..65535

///////////////////////////////////////////////////////////// ANALYSIS

CALIBRATION FORM FACTOR

especially for lower frequencies (with decimals)

adding offsets works well in normal range might introduce under- or overflow at the ends of the sensor range

allows 1st order calibration

adding offsets works well in normal range might introduce under- or overflow at the ends of the sensor range

adding offsets works well in normal range might introduce under- or overflow at the ends of the sensor range

to set the speed the I2C bus should return to as the device operates at very low bus speed of 30 kHz.

SETTERS

//////////////////////////////////////////////////////////////////////// EXPERIMENTAL

///////////////////////////////////////////// MODE

noise 0..255; in practice only small values are used (0..10).

CALIBRATION NOISE noise defaults 21 datasheet

use offset to calibrate the TC.

use offset to calibrate the TC.

/////////////////////////////////////////////////////// STREAMING MODE output fields should be OR-ed e.g. SetOutputFields(CZR_HUMIDITY | CZR_RAWTEMP

tune the output range, default 0..100