Copy a segment of this vector into another. @param other The other vector (to copt into starting at 0.) @param start The start point in this vecto

Index a single bit. */

Set the size for encoder/decoder channels. The size should be inited once and then never change, so we throw an assertion if it does.

Define some funcs we need so we dont have to link with the entire OpenBTS-UMTS

Various ways to get the data out:

This is the TrCh config function, which uses TrCh id numbered starting with 1. The arrays where we save TrCh stuff are 0 based. The complicated RBMapp

Set the Write Position for appends. This is equivalent to setting size().

Wait until the queue falls below a low water mark. */ (pat) This function suffers from the same problem as documented at InterthreadQueue.write(), but

Uplink data info table.

Read a bit field starting at specified byte and bit, each numbered from 0. Bit numbering is from high to low, like this: getField bitIndex: 0 | 1 | 2

Configuration Functions:

Skip over an IE we dont care about:

Like asn_fprint but return the result in a C++ string.

Reserve a downlink channel for something other than DCH. NOTE: A reservation only blocks a specific channel and unlike active() channels are not consi

This status is sent back to the MS in messages to indicate what the Network thinks what PDPContexts are currently in use.

Return the transport block size rounded down to the size accepted by the rlc-size IE parameter. It is different for common and dedicated channels. De

unary functions -- inlined @name unary functions */ @{ @name inlined */ @{

The specs give the low nibble first, then the high nibble.

Peek at front item without removal. */

The getRB works for RB or SRB.

Return a segment of a ByteVector that shares the same memory as the original.

Set the PowerOffset for the most recently defined CTFC

@name Basic accessors. */ @{

@name Accessors. */ @{

unary functions -- inlined @name unary functions */ @{ @name inlined */ @{

25.331 13.8 for RB1, RB2, RB3

Same result as PhCh::getDlRadioFrameSize but if you dont have a channel pointer handy.

Read an L3Frame from SAP3. Throw exception on failure. Will NOT return a NULL pointer. */

25.331 10.3.3.36 The transaction id in the messages is only 2 bits.

Non-blocking read. @param key Key to read from. @return Pointer at key or NULL if key not found. */

TODO: What to do with SAPI?

Remaining time in ms. */