Coordinate transformation from ECEF coordinates to latitude/longitude/altitude */

* \brief Get flash wait state. * * \param p_efc Pointer to an EFC instance. * * \return The number of wait states in cycle (no shift). */

* \brief Initialize the EFC controller. * * \param ul_access_mode 0 for 128-bit, EEFC_FMR_FAM for 64-bit. * \param ul_fws The number of wait states

Returns 0 on success

* \brief Lock all the regions in the given address range. The actual lock * range is reported through two output parameters. * * \param ul_start St

* Retrieve the 32 bit unsigned integer value of the specified bits - note that no bounds checking is done on buffer * @param buffer the buffer contain

Because formatting using c++ streams is stateful, drop down to C is required Alternatively we could use stringstream, but its performance is... not go

IContext

* Returns the timestamp in seconds and microseconds * @param secs seconds * @param usecs microseconds */

Return a boolean indicating whether a flag name is supported on the specified compiler.

* @fn sint8 hif_check_compatibility(uint16 u16HifInfo); * @brief * To check the compatibility of an image with the current driver. * @param [in]

the internal ID of the edge

* \brief Initializes the IOPORT service, ready for use. * * This function must be called before using any other functions in the IOPORT * service.

Coordinate transformation from latitude/longitude/altitude to ECEF coordinates */

! @fn \ sint8 m2m_ate_get_rx_status(uint8); @brief This function used to return status of RX test case either running or stopped. @return The fun

=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=* STATIC FUNCTIONS *=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

Performs equivalent check of std::fabs(lhs - rhs) <= margin But without the subtraction to allow for INFINITY in comparison

* \brief Set Rx acknowledge. * * \param[in] module_inst Pointer to the MCAN software instance struct * \param[in] fifo_number Rx FIFO 0 or 1 * \

* \brief Get Rx FIFO status. * * \param[in] module_inst Pointer to the MCAN software instance struct * \param[in] fifo_number Rx FIFO 0 or 1 *

* \brief CMD8 - The card sends its EXT_CSD register as a block of data. * * \param b_authorize_high_speed Pointer to update with the high speed * s

* \brief Decodes MMC CSD register */