Setup
| 54 | |
| 55 | // Setup |
| 56 | inline void Scan_setup() |
| 57 | { |
| 58 | // Setup Port Swap module |
| 59 | Port_setup(); |
| 60 | |
| 61 | // Setup UART Connect, if Output_Available, this is the master node |
| 62 | Connect_setup( Output_Available ); |
| 63 | |
| 64 | // Setup GPIO pins for matrix scanning |
| 65 | Matrix_setup(); |
| 66 | |
| 67 | // Setup ISSI chip to control the leds |
| 68 | LED_setup(); |
| 69 | |
| 70 | // Setup Pixel Map |
| 71 | Pixel_setup(); |
| 72 | |
| 73 | // Reset scan count |
| 74 | Scan_scanCount = 0; |
| 75 | } |
| 76 | |
| 77 | |
| 78 | // Main Detection Loop |
nothing calls this directly
no test coverage detected
searching dependent graphs…