MCPcopy Create free account

hub / github.com/dalathegreat/Battery-Emulator / functions

Functions2,739 in github.com/dalathegreat/Battery-Emulator

MethodRS485_EN_PIN
Software/src/devboard/hal/hw_lilygo.h:13
MethodRS485_EN_PIN
Software/src/devboard/hal/hw_waveshare.h:21
MethodRS485_RX_PIN
Software/src/devboard/hal/hw_lilygo2can.h:47
MethodRS485_RX_PIN
Software/src/devboard/hal/hw_devkit.h:19
MethodRS485_RX_PIN
Software/src/devboard/hal/hw_3LB.h:11
MethodRS485_RX_PIN
Software/src/devboard/hal/hw_becom.h:14
MethodRS485_RX_PIN
Software/src/devboard/hal/hw_stark.h:33
MethodRS485_RX_PIN
Software/src/devboard/hal/hw_lilygo.h:15
MethodRS485_RX_PIN
Software/src/devboard/hal/hw_waveshare.h:15
MethodRS485_SE_PIN
Not needed, GPIO 19 is available as extra GPIO via pin header
Software/src/devboard/hal/hw_stark.h:35
MethodRS485_SE_PIN
Software/src/devboard/hal/hw_lilygo.h:16
MethodRS485_SE_PIN
Software/src/devboard/hal/hw_waveshare.h:22
MethodRS485_TX_PIN
Note: these are used by the bootloader UART, so there'll be some bootloader chatter sent down the RS485 bus when the chip starts up. Hopefully this wo
Software/src/devboard/hal/hw_lilygo2can.h:46
MethodRS485_TX_PIN
Software/src/devboard/hal/hw_devkit.h:18
MethodRS485_TX_PIN
Software/src/devboard/hal/hw_3LB.h:10
MethodRS485_TX_PIN
Software/src/devboard/hal/hw_becom.h:13
MethodRS485_TX_PIN
Software/src/devboard/hal/hw_stark.h:32
MethodRS485_TX_PIN
Software/src/devboard/hal/hw_lilygo.h:14
MethodRS485_TX_PIN
Software/src/devboard/hal/hw_waveshare.h:14
MethodRTSauto
RTSauto: dummy callback for auto half duplex RS485 boards
Software/src/lib/eModbus-eModbus/RTUutils.h:50
MethodRTUutils
Software/src/lib/eModbus-eModbus/RTUutils.h:65
MethodRamString
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:988
MethodRawComparer
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:4452
FunctionReader
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:6352
MethodReader
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:6252
MethodReader
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:6287
MethodReader
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:6303
MethodReader
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:6325
MethodRelionBattery
Use this constructor for the second battery.
Software/src/battery/RELION-LV-BATTERY.h:12
MethodRenaultZoeGen1Battery
Use this constructor for the second battery.
Software/src/battery/RENAULT-ZOE-GEN1-BATTERY.h:12
MethodRenaultZoeGen2Battery
Use this constructor for the second battery.
Software/src/battery/RENAULT-ZOE-GEN2-BATTERY.h:10
MethodResourceManager
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:2637
MethodRjxzsBms
Software/src/battery/RJXZS-BMS.h:9
MethodRs485InverterProtocol
Software/src/inverter/Rs485InverterProtocol.h:14
MethodSD_CS_PIN
Software/src/devboard/hal/hw_3LB.h:63
MethodSD_CS_PIN
Software/src/devboard/hal/hal.h:191
MethodSD_CS_PIN
Software/src/devboard/hal/hw_lilygo.h:95
MethodSD_MISO_PIN
SD card
Software/src/devboard/hal/hw_3LB.h:60
MethodSD_MISO_PIN
SD card
Software/src/devboard/hal/hw_lilygo.h:77
MethodSD_MOSI_PIN
Software/src/devboard/hal/hw_3LB.h:61
MethodSD_MOSI_PIN
Software/src/devboard/hal/hw_lilygo.h:83
MethodSD_SCLK_PIN
Software/src/devboard/hal/hw_3LB.h:62
MethodSD_SCLK_PIN
Software/src/devboard/hal/hw_lilygo.h:89
MethodSECOND_BATTERY_CONTACTORS_PIN
Software/src/devboard/hal/hw_lilygo2can.h:86
MethodSECOND_BATTERY_CONTACTORS_PIN
Software/src/devboard/hal/hw_devkit.h:47
MethodSECOND_BATTERY_CONTACTORS_PIN
Software/src/devboard/hal/hw_3LB.h:48
MethodSECOND_BATTERY_CONTACTORS_PIN
SECOND_BATTERY_CONTACTORS_PIN mapped to the Battery 2 Negative Contactor Pin
Software/src/devboard/hal/hw_becom.h:43
MethodSECOND_BATTERY_CONTACTORS_PIN
Software/src/devboard/hal/hw_stark.h:74
MethodSECOND_BATTERY_CONTACTORS_PIN
Software/src/devboard/hal/hw_lilygo.h:59
MethodSECOND_BATTERY_CONTACTORS_PIN
Software/src/devboard/hal/hw_waveshare.h:37
MethodSantaFePhevBattery
Use this constructor for the second battery.
Software/src/battery/SANTA-FE-PHEV-BATTERY.h:9
MethodSerializedValue
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:1455
MethodSetUp
test/voltage_sync_tests.cpp:9
MethodSetUp
test/can_log_based/canlog_safety_tests.cpp:23
MethodSetUp
test/battery/still_alive_tests.cpp:15
MethodSlot
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:350
MethodSmaInverterBase
Software/src/inverter/SmaInverterBase.h:11
MethodStaticStringWriter
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:5153
MethodStellantisSmallWide4x4Battery
Use this constructor for the second battery.
Software/src/battery/STELLANTIS-SMALL-WIDE-4x4.h:9
MethodString
Constructors
test/emul/WString.h:16
FunctionStringBuilder
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:5427
MethodStringBuilderPrint
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:5665
MethodStringPool
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:1363
MethodSungrowInverter
Constructor: request 250 kbps on the inverter CAN interface
Software/src/inverter/SUNGROW-CAN.h:16
FunctionTEST
Test a BMS reqest sequence from end to end. This is for the case where the contactors are powered directly by BE, so the reset doesn't need to wait fo
test/bms_reset_tests.cpp:15
FunctionTEST
test/battery/NissanLeafTest.cpp:6
FunctionTEST_F
Test: When voltages are in sync, battery2 is allowed to close contactors
test/voltage_sync_tests.cpp:22
MethodTRIPLE_BATTERY_CONTACTORS_PIN
Software/src/devboard/hal/hw_lilygo2can.h:87
MethodTRIPLE_BATTERY_CONTACTORS_PIN
Software/src/devboard/hal/hw_devkit.h:48
MethodTRIPLE_BATTERY_CONTACTORS_PIN
Software/src/devboard/hal/hw_3LB.h:49
MethodTRIPLE_BATTERY_CONTACTORS_PIN
Software/src/devboard/hal/hw_stark.h:75
MethodTRIPLE_BATTERY_CONTACTORS_PIN
Software/src/devboard/hal/hw_lilygo.h:64
MethodTearDown
test/can_log_based/canlog_safety_tests.cpp:54
MethodTearDown
test/battery/still_alive_tests.cpp:29
MethodTeslaBattery
Use the default constructor to create the first or single battery.
Software/src/battery/TESLA-BATTERY.h:19
MethodTestBody
test/can_log_based/canlog_safety_tests.cpp:96
MethodTestBody
test/can_log_based/canlog_safety_tests.cpp:120
MethodTestBody
test/can_log_based/canlog_safety_tests.cpp:131
MethodTestBody
test/can_log_based/canlog_safety_tests.cpp:143
MethodTestBody
test/can_log_based/canlog_safety_tests.cpp:155
MethodTestBody
test/battery/still_alive_tests.cpp:44
MethodTestFakeBattery
Use this constructor for the second battery.
Software/src/battery/TEST-FAKE-BATTERY.h:9
MethodTestNotStillAlive
test/battery/still_alive_tests.cpp:43
MethodTextFormatter
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:5000
MethodVariantComparer
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:4467
FunctionVariantContent
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:2104
MethodVariantData
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:2150
MethodVisitorAdapter
Software/src/lib/bblanchon-ArduinoJson/ArduinoJson.h:4349
MethodWUP_PIN1
Battery wake up pins
Software/src/devboard/hal/hw_lilygo2can.h:131
MethodWUP_PIN1
Battery wake up pins
Software/src/devboard/hal/hw_devkit.h:67
MethodWUP_PIN1
Battery wake up pins
Software/src/devboard/hal/hw_3LB.h:73
MethodWUP_PIN1
Battery wake up pins
Software/src/devboard/hal/hw_becom.h:63
MethodWUP_PIN1
Battery wake up pins
Software/src/devboard/hal/hw_stark.h:98
MethodWUP_PIN1
Battery wake up pins
Software/src/devboard/hal/hw_lilygo.h:109
MethodWUP_PIN1
Battery wake up pins
Software/src/devboard/hal/hw_waveshare.h:43
MethodWUP_PIN2
Software/src/devboard/hal/hw_lilygo2can.h:138
MethodWUP_PIN2
Software/src/devboard/hal/hw_devkit.h:68
MethodWUP_PIN2
Software/src/devboard/hal/hw_3LB.h:74
MethodWUP_PIN2
Software/src/devboard/hal/hw_becom.h:64
MethodWUP_PIN2
Software/src/devboard/hal/hw_stark.h:99
← previousnext →1,301–1,400 of 2,739, ranked by callers