/////////////////////////////////////////////////////////////////////////// class DsoConfigDialog \brief Creates the configuration dialog and sets ini

\brief Set the number of channels. \param channels The new channel count, that will be applied to lists.

/////////////////////////////////////////////////////////////////////////// class LevelSlider \brief Initializes the slider container. \param directio

VID/PID active VID/PID no FW FW ver FW name Scope name |------------| |------------| |----| |------| |------|

DEMO similar to Hantek DSO-6022BE VID/PID active VID/PID no FW FW ver FW name Scope name |------------| |------------| |----| |----| |----|

Voltcraft DSO-2020 USB Oscilloscope (HW is identical to 6022) Scope starts up as model DS-2020 (VID/PID = 04b4/2020) but loads 6022BE firmware and loo

Hantek DSO-6021 (DIY redesign) VID/PID active VID/PID no FW FW ver FW name Scope name |------------| |------------| |------------|

Hantek DSO-6022BE (this is the base model) VID/PID active VID/PID no FW FW ver FW name Scope name |------------| |------------| |---

Hantek DSO-6022BL (scope or logic analyzer)

LCSOFT without EEPROM reports EzUSB VID/PID

Instrustar ISDS20A/B VID/PID active VID/PID no FW FW ver FW name Scope name |------------| |------------| |------------| |-------|

VID/PID active VID/PID no FW FW ver FW name Scope name |------------| |------------| |----| |----| |----|

Saleae VID/PID in EEPROM

/////////////////////////////////////////////////////////////////////////// class OpenHantekMainWindow \brief Initializes the SiSpinBox internals. \pa

\brief Analyzes the data from the dso.

\brief Set the trigger level sliders minimum and maximum to the new values.

\brief Handles signals affecting trigger position in the zoom view.

\brief Saves the settings.

Initialize the device with the current settings.

\brief Bulk write to the oscilloscope. \param data Buffer for the sent/received data. \param length The length of the packet. \param attempts The numb

\brief Calculate the drawing area for the slider for it's current value. \param sliderId The id of the slider whose rect should be calculated. \return

\brief Search for the widest slider element. \return The calculated width of the slider.

\brief Change the config page. \param current The page that has been selected. \param previous The page that was selected before.

\brief Save the settings before exiting. \param event The close event that should be handled.

\brief Don't close the dock, just hide it. \param event The close event that should be handled.

\brief Don't close the dock, just hide it \param event The close event that should be handled.

\brief Don't close the dock, just hide it \param event The close event that should be handled.

\brief Don't close the dock, just hide it \param event The close event that should be handled.

static

\brief Create the icons for the pages.

static

static

\brief Return the direction of the sliders. \return The side on which the sliders are shown.

draw 4 small crosses @ (x,y), (-x,y), (x,-y) and (-x,-y) section 0:grid, 1:axes, 2:border