This is for the MCP4018 I2C based digipot

* For the specified 'axis' set the Maximum Acceleration to the given value (mm/s^2). * The value may be limited with warning feedback, if configured.

* For the specified 'axis' set the Maximum Feedrate to the given value (mm/s). * The value may be limited with warning feedback, if configured. * *

* Software endstops can be used to monitor the open end of * an axis that has a hardware endstop on the other end. Or * they can prevent axes fr

* @brief check if font is loaded */

Refreshes the watchdog timer to prevent system reset

* Write a 512 byte block to an SD card. * * \param[in] blockNumber Logical block to be written. * \param[in] src Pointer to the location of the dat

Main Menu: "Advanced Settings"

Main Menu: "Print"

Printing: "Stop"

Printing: "Tune"

* Invalidate all general purpose registers. */

* Get the next frame unwinding instruction * * Return either the instruction or -1 to signal no more instructions * are available */

Before homing, blink '123' <-> '???'. Homed but unknown... '123' <-> ' '. Homed and known, display constantly.

Move to position routines

Native BLTouch commands ("Underscore"...), used in lcd menus and internally

* rx, ry, rz - Cartesian positions in mm * Leveled XYZ on completion */

We don't care about indices here, since if one can call us, it's the right index anyway

* Check for valid pin number * @param[in] pin Number of pin to be checked. */

This extra chit-chat goes away soon, but is helpful for now to see errors that are happening in read_data / write_data

* @brief Removes and returns a item from the queue * @details Removes the oldest item on the queue, pointed to by the * buffer_t

* Note: This assumes you're on a LeafLabs-style board * (CYCLES_PER_MICROSECOND == 72, APB2 at 72MHz, APB1 at 36MHz). */

Get the analog index for a digital pin