query the fallback state @return true if fallback is enabled. */

query the fallback state @return true if fallback is enabled. */

Get the gear extend/retract command. 0 commands gear up, 1 down. defaults to down. @return the current value of the gear extend/retract co

Gets the gear position (0 up, 1 down), defaults to down @return gear position (0 up, 1 down) */

Gets the geodetic altitude in feet. */

Get the GEODETIC latitude in degrees. @return the geodetic latitude in degrees of the location represented by this class instance. The ret

Gets the initial geodetic latitude. @return Initial geodetic latitude in degrees */

Get the GEODETIC latitude in radians. @return the geodetic latitude in rad of the location represented with this class instance. The retur

Gets the initial geodetic latitude. @return Initial geodetic latitude in radians */

Get the gravity type.

Retrieves the ground effect scaling factor.

Retrieves a gust component in NED frame.

Retrieves the Mach number at the propeller tips.

Gets the value of the property forces/hold-down. @result zero if the 'hold-down' function is disabled, non-zero otherwise. */

Returns a pointer to the FGInitialCondition object

Get the propeller induced velocity.

Retrieves the total inertial velocity in ft/sec. */

Returns the kinematic viscosity.

Gets the left brake. @return the left brake setting. */

Retrieves the inflow ratio

Retrieves the lateral control input in radians.

Get the GEOCENTRIC latitude in radians. @return the geocentric latitude in rad of the location represented with this class instance. The r

Get the GEOCENTRIC latitude in degrees. @return the geocentric latitude in deg of the location represented with this class instance. The r

Gets the initial latitude. @return Initial geocentric latitude in degrees */

Gets the initial latitude. @return Initial latitude in radians */

Retrieves the lift over drag ratio */

Get the longitude. @return the longitude in rad of the location represented with this class instance. The returned values are in the range

Get the longitude. @return the longitude in deg of the location represented with this class instance. The returned values are in the range

Gets the initial longitude. @return Initial longitude in degrees */

Gets the initial longitude. @return Initial longitude in radians */

Retrieves the longitudinal control input in radians.

Gets the Mach number. */

The mach number calculated using the vehicle X axis velocity. */

Get the current mass of the ballonets @return mass in slug. */

Gets the mixture command. @param engine engine ID number @return mixture command for the given engine @note The mixture command is general

Gets the mixture position. @param engine engine ID number @return mixture position for the given engine @note The mixture position i

Gets the aerodynamic moment about the CG for an axis. @return the moment about a single axis (as described also in the similar cal

Retrieves a component of the total moments applied on the body. Retrieves a component of the total moments applied on the body. This does