* @brief This function is an application I/F function which is used to send the data for other then TCP mode. * Unlike TCP transmission, The peer'

sets the alarm handler

sets the value of the checkForConversion flag TRUE : function requestTemperature() etc will 'listen' to an IC to determine whether a conversion is com

sets the high alarm temperature for a device in degrees Celsius accepts a float, but the alarm resolution will ignore anything after a decimal point.

sets the pin to be monitored, and set the Arduino pinMode based on constructor data

sets

sets the low alarm temperature for a device in degrees Celsius accepts a float, but the alarm resolution will ignore anything after a decimal point.

note if device is not connected it will fail writing the data.

sets the value of the waitForConversion flag TRUE : function requestTemperature() etc returns when conversion is ready FALSE: function requestTemperat

* @fn spi_flash_erase * @brief Erase from data from SPI flash * @param[IN] u32Offset * Address to write to at the SPI flash * @param[IN] u32Sz

* @fn spi_flash_get_size * @brief Get size of SPI Flash * @return Size of Flash * @author M.S.M * @version 1.0 */

* @fn spi_flash_read * @brief Read from data from SPI flash * @param[OUT] pu8Buf * Pointer to data buffer * @param[IN] u32offset * Address

* @fn spi_flash_write * @brief Proram SPI flash * @param[IN] pu8Buf * Pointer to data buffer * @param[IN] u32Offset * Address to write to a

Function sslEnableCertExpirationCheck Description Enable/Disable TLS Certificate Expiration Check. Return Author Ahmed Ezzat Version 1.0 Dat

Start server TCP on port specified

Release any resources being used by this WiFiUDP instance */

Start server TCP on port specified

* Switch a remote switch off (Type D REV) * * @param sGroup Code of the switch group (A,B,C,D) * @param nDevice Number of the switch i

* Switch a remote switch on (Type D REV) * * @param sGroup Code of the switch group (A,B,C,D) * @param nDevice Number of the switch it

Setup the search to find the device type 'family_code' on the next call to search(*newAddr) if it is present.

copied from Serial::timedRead

Convert float Fahrenheit to Celsius

Convert float Celsius to Fahrenheit

update function

update function

update function

Update the network State/LED

private

returns true if address is valid

private

private

private

private

private

private

destructor