read from peripheral without the read barrier

Release pigpio resources. ... pi.stop() ...

This is the toplevel function for the hv line draw procedures. This function should be called by the user. */

upper limits are not included (asymetric boundaries) */

removed NOINLINE, because it leads to smaller code, might also be faster */ static uint8_t u8g2_font_get_byte(const uint8_t *font, uint8_t offset) U8G

Returns count bytes from the command socket.

Set/clear only the bits in value covered by the mask

Append a token and return a new Pointer ! \param token Token to be appended. \param allocator Allocator for the newly return Pointer.

Call the read method and return temperature and humidity informations.

Function: It sets the timeout according to the configured mode. Returns: Integer that determines if there has been any error state = 2 --> The co

Const \em past-the-end member iterator ! \pre IsObject() == true */

Provides a count of how many times the default tally callback has triggered. The count will be zero if the user has supplied their

defaults to 0, which means a divider of 65536. The divisor must be a power of 2. Odd numbers rounded down. The maximum SPI clock rate is of the APB cl

safe read from peripheral

Returns 1 if a waveform is currently being transmitted, otherwise 0. ... pi.wave_send_once(0) # send first waveform w

wrapper for AutoUTFInputStream

Starts (non-zero dutycycle) or stops (0) PWM pulses on the GPIO. user_gpio:= 0-31. dutycycle:= 0-range (range defaults to 255).

Sets or clears the internal GPIO pull-up/down resistor. gpio:= 0-53. pud:= PUD_UP, PUD_DOWN, PUD_OFF. ... pi.set_pul